Craftsman 247.375910 Operator's Manual page 18

21” lawn mower
Hide thumbs Also See for 247.375910:
Table of Contents

Advertisement

Oil
Check oil level regularly.
Be sure correct oil level is maintained. Check every five hours or daily before
starting engine. See oil checking procedure in the Operation section.
Change Engine Oil
Gasoline and its vapors are extremely flammable and explosive. Fire or
explosion can cause severe burns or death.
Change engine oil after the first five hours of operation, and every fifty hours or
once a season thereafter.
Before tipping the unit to drain the oil, the fuel tank must be empty or fuel
can leak out and result in a fire or explosion. To empty the fuel tank, run
the engine until it stops from lack of fuel.
IMPORTANT: Be sure to check engine on a level surface with the engine stopped.
Drain the oil while the engine is still warm to assure rapid and complete draining.
1.
With engine off but still warm, disconnect the spark plug wire and keep it
away from the spark plug.
2.
Place a suitable container next to the engine to catch the used oil.
3.
Remove the drain plug and drain the oil into the container by tipping the
engine toward the oil fill/dipstick. See Figure 18.
Used oil is a hazardous waste product. Dispose of used oil properly. Do not
discard with household waste. Check with your local authorities or Sears
Service Center for safe disposal/recycling facilities.
4.
Reinstall the drain plug and tighten it securely.
5.
Refill with the recommended oil and check the oil level. Refer to the
Operation Section.
Running the engine with a low oil level can cause engine damage.
6.
Reinstall the oil fill dipstick securely.
Carbon Canister Filter
The foam carbon canister filter must be cleaned or replaced once a year or every 100
operating hours.
1.
Remove the nuts securing the recoil housing as shown in Figure 19 and
remove.
2.
After removing the recoil housing, remove the nuts securing the inner
shroud.
3.
Lift up inner engine shroud and carefully pull out carbon canister filter
assembly from under shroud as shown in Figure 20.
4.
Remove cap from end of canister and pull out round foam filter from inside
the assembly. See Figure 20. Clean element or replace when damaged.
SERVICE AND MAINTENANCE
WARNING
WARNING
CAUTION
CAUTION
Oil Fill/ Dipstick
Nut
Inner Shroud
Foam Filter
Cap
18
Air Filter
Figure 18
Figure 19
Figure 20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents