Maintenance; Ec Declaration Of Conformity - Makita 2414NB Instruction Manual

Cutting capacity
Max. cutting capacity varies depending upon the cutting angle and workpiece shape.
Applicable wheel diameter: 355 mm.
Workpiece
shape
Cutting
angle
90°
45°
For tools with the under cover (Fig. 13)
To remove the collected dust from the under cover, place
the tool with its side up and pull the under cover open
after removing the wing bolt as shown in the figure. Be
sure to close and secure the under cover with the wing
bolt after the removal of dust.
Carrying the tool (Fig. 14)
Fold down the tool head to the position where you can
attach the chain to the hook on the handle.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Replacement of carbon brushes (Fig. 15 & 16)
Replace carbon brushes when they are worn down to the
limit mark. Both identical carbon brushes should be
replaced at the same time.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
8
A
115 mm 119 mm
115 mm 106 mm
A
A x B
A
115 mm x 130 mm
102 mm x 194 mm
70 mm x 233 mm
115 mm x 103 mm
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 97 dB (A)
sound power level:
– Wear ear protection. –
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product
is in compliance with the following standards of standard-
ized documents,
EN61029, EN55014, EN61000
in accordance with Council Directives, 73/23/EEC,
89/336/EEC and 98/37/EC.
Yasuhiko Kanzaki
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes,
Bucks MK15 8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
B
A
137 mm
100 mm
110 dB (A)
2
.
CE 2005
Director
A
ENG005-1
ENH003-4