Table of Contents
Advertisement
Connecting to the TV
1 Switch off your TV set.
2 Remove the aerial cable plug from your TV set. Insert it into the
ANTENNA IN socket at the back of the DVD recorder.
3 Insert one end of the supplied aerial cable into the TV
OUT socket at the back of the DVD recorder and the other end
into the aerial input socket at the back of the TV set.
4 Connect socket EXT1 TO TV-I/O or sockets S-VIDEO OUT
(Y/C) , VIDEO OUT (CVBS) , AUDIO OUT L/R with the
corresponding sockets of your TV set.
Connecting to the mains
Always check if the local mains voltage matches the voltage range
printed on the type plate at the back or bottom of the DVD-recorder.
If not consult your dealer or the customer support from your country.
1 Switch on the TV set.
2 Insert one end of the supplied mains cable into the mains socket
4MAINS at the back of the DVD recorder and the other end
into the wall socket.
Initial installation
1 Press STANDBY-ON m on the front of the DVD-recorder
P
'PHILIPS' and then 'IS TV ON?' will appear on the display.
2 If necessary, select the programme number for the input socket at
the TV set.
P
The initial installation menu appears on the screen.
Menu Language
English
Español
Français
Italiano
Deutsch
Press OK to continue
3 Select your favourite setting using B or A .
Confirm with OK .
4 Proceed in the same way with the further menus: 'Audio
Language', 'Subtitle', 'TV shape' , 'Country' .
P
The Automatic channel serach starts after the confirmation of
the message 'If you have connected the antenna - press
OK ' using OK .
P
After all channels have been found, the menu for Time/Date
setting appears.
Check the data displayed and change them if necessary
5 Press OK to continue set up.
6 Select 'No ' for watching the Demo movie ('Dealer mode ') and
confirm using OK . This setting is only for Dealers. You can watch
the movie's also in the media browser.
Switch off the Dealer Demo
If you have switched on the Demo Movie, repeat play back of the movie
starts automatically.
To switch it off proceed as follows:
- Press DISC MENU and then SYSTEM MENU (call up the
system menu from the disc).
' using D , and then '
- Select the symbol '
A
- Confirm with C .
- Select 'Standby' using B and confirm using C .
- Select 'Low power' or 'Normal' using B , A .
- Confirm with OK and end with SYSTEM MENU .
Quick install guide
Virgin mode
' using B .
w
5
Advertisement
Table of Contents
