Optional Accessories; Protecting The Environment - DeWalt DCD700 Original Instructions Manual

EN G LI SH
stalling. DO NOT CLICK TRIGGER ON
AND OFF IN AN ATTEMPT TO START A
STALLED DRILL — THIS CAN DAMAGE
THE DRILL.
5. To minimize stalling or breaking through the
material, reduce pressure on drill and ease the
bit through the last fractional part of the hole.
6. Keep the motor running when pulling the bit
back out of a drilled hole. This will help prevent
jamming.
7. With variable speed drills there is no need to
center punch the point to be drilled. Use a
slow speed to start the hole and accelerate by
squeezing the trigger harder when the hole is
deep enough to drill without the bit skipping
out.
Operation as a Screwdriver
Select the desired speed/torque range using the
dual range gear shifter on the top of tool to match
the speed and torque to the planned operation.
Insert the desired fastener accessory into the chuck
as you would any drill bit. Make a few practice runs
in scrap or unseen areas to determine the proper
position of the clutch collar.
MAXIMUM RECOMMENDED CAPACITIES
Low Range–1
Bits, Metal
6.35 mm (1/4")
Drilling
Wood, Flat
19.05 mm (3/4")
Boring
Hole Saws 19.05 mm (3/4") 15.88 mm (5/8")
MAINTENANCE
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk
of serious personal injury, place
the forward/reverse button in
the lock-off position or turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
12
Lubrication
Your power tool requires no additional lubrication.
Cleaning
CHARGER CLEANING INSTRUCTIONS
High Range–2
3.18 mm (1/8")
12.7 mm (1/2")

Optional Accessories

Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
e
accessories should be used with this
product.
Separate collection. This product must
not be disposed of with normal
household waste.
WALT, have
e