Table of Contents
Advertisement
6131.ENv1_NFC_9203947_UG.fm Page 13 Tuesday, May 15, 2007 2:52 PM
■
Switch the phone on and off
Warning: Do not switch the phone on when wireless phone use is prohibited or
when it may cause interference or danger.
To switch the phone on or off, press and hold the power key. See "Keys and parts," p. 14.
If the phone prompts for a PIN or UPIN code, enter the code (displayed as ****), and select OK.
Set the time, time zone, and date
Enter the local time, select the time zone of your location in terms of the time difference
with respect to Greenwich Mean Time (GMT), and enter the date. See "Time and date," p. 44.
Plug and play service
When you switch on your phone for the first time, and the phone is in the standby mode, you
are asked to get the configuration settings from your service provider. Confirm or decline the
query. See Connect to serv. support in "Configuration," p. 51, and "Configuration settings
service," p. 9.
■
Antenna
Your device has an internal antenna.
Note: As with any radio transmitting device,
avoid touching an antenna unnecessarily when
the antenna is in use. For example, avoid
touching the cellular antenna during a phone
call. Contact with a transmitting or receiving
antenna affects the quality of the radio
communication, may cause the device to
operate at a higher power level than otherwise
needed, and may reduce the battery life.
■
Phone strap
Thread the strap through the eyelet of the phone as
shown in the picture, and tighten it.
13
Advertisement
Table of Contents
