Removing A Ciov-Form-Factor Expansion Card - Lenovo HS23 Installation And User Manual

6. Locate the CIOv expansion connector (see "Blade server connectors" on page
7. Orient the connector on the expansion card with the CIOv expansion connector
8. Firmly press on the indicated locations to seat the expansion card.
9. If you have other devices to install or remove, do so now; otherwise, go to

Removing a CIOv-form-factor expansion card

Use these instructions to remove a CIOv-form-factor expansion card in the blade
server.
The following illustration shows how to remove a vertical-combination-I/O (CIOv)
expansion card.
To remove a CIOv expansion card, complete the following steps:
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see "Removing the blade server cover" on page
5. Touch the static-protective package that contains the expansion card to any
6. Locate the CIOv expansion connector (see "Blade server connectors" on page
42
BladeCenter HS23 Types 7875 and 1929: Installation and User's Guide
15).
on the system board; then, press the card into the CIOv expansion connector.
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
expansion card.
"Completing the installation" on page 45.
page 17.
the blade server from the BladeCenter unit" on page 20 for instructions).
21 for instructions).
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the expansion card from
the package.
15).