Makita HM1801 Instruction Manual page 7

1
006203
Remove the cap rubber.
1
008624
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
006204
Lubrication
1
008494
1. Hex wrench 5
2
2. Motor housing
cover
1. Cap rubber
1. Brush holder
2
cap
2. Screwdriver
1. Cap
2
2. Lock nut wrench
20
1
008495
This tool requires no hourly or daily lubrication because
it has a grease-packed lubrication system. It should be
relubricated after every 6 months of operation. Send the
complete tool to Makita Authorized or Factory Service
Center for this
circumstances require that you should lubricate it by
yourself, proceed as follows.
First, switch off and unplug the tool.
Remove the cap using a lock nut wrench 20 or hex
wrench 8, then replenish with fresh grease (60 g). Use
only Makita genuine
accessory). Filling with more than the specified amount
of grease (approx. 60 g) can cause faulty hammering
action or tool failure. Fill only with the specified amount
of grease.
1
006206
Reinstall the cap and secure with the wrench.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
7
1. Cap
2
2. Hex wrench 8
lubrication service.
hammer grease
1. Hammer grease
or attachments
Only use accessory or
However, if
(optional
are