Service Note - Sony D-NE510 Service Manual

QQ
3 7 63 1515 0
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electro-
static breakdown because of the potential difference generated by
the charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
Precautions for Checking Emission of Laser Diode
Laser light of the equipment is focused by the object lens in the
optical pick-up so that the light focuses on the reflection surface
of the disc. Therefore, be sure to keep your eyes more then 30 cm
apart from the object lens when you check the emission of laser
diode.
Before Replacing the Optical Pick-Up Block
Please be sure to check throughly the parameters as par the "Opti-
cal Pick-Up Block Checking Procedures" (Part No.: 9-960-027-
11) issued separately before replacing the optical pick-up block.
Note and specifications required to check are given below.
• FOK output : IC601 yg pin (or TP618 (FOK))
When checking FOK, remove the lead wire to disc motor.
• RF signal P-to-P value : 0.45 ± 0.1 Vp-p
• The repairing grating holder is impossible.
Laser Diode Checking Methods
During normal operation of the equipment, emission of the laser
TE
L 13942296513
diode is prohibited unless the upper lid is closed while turning ON
the S820. (push switch type)
The following two checking methods for the laser diode are
operable.
• Method:
Emission of the laser diode is visually checked.
1. Open the upper lid.
2. With a disc not set, turn on the S820 with a screwdriver having a
thin tip as shown in Fig.1.
or TAP805 is shorted as shown in Fig.2.
Note: Do not push the detection lever strongly, or it may be bent
or damaged.
3. Press the N X button.
4. Observing the objective lens, check that the laser diode emits
light.
When the laser diode does not emit light, automatic power
control circuit or optical pick-up is faulty.
In this operation, the objective lens will move up and down 5
times along with inward motion for the focus search.
www
.
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
SECTION 1

SERVICE NOTE

2 9
8
– MAIN BOARD – (SIDE B)
TP422
TJ402
C447
Q Q
3 6 7 1 3 1 5
– MAIN BOARD – (SIDE A)
FB402
TP911
co
TAP805
.
D-NE510/NE511/NE518CK
9 4 2 8
detection lever
detection lever
main board
S820
R612
C853
C107
C207
TP939
TP942
TP940
TP941
0 5 8 2 9 9 4
S820
TJ503
R495 (OPEN/CLOSE)
TP826
TJ501
TJ502
R498
C808
TJ406(VCPU)
FB403
TP820
R487
S820
Fig. 1
SL806
R606
TP910
m
TAP805
Fig. 2
9 9
13 12 TP934
TP933
IC301
TP932
24 1
C305
2 8 9 9
R947
C306
TP930
R943
R806
TP929
S804
FB410
R427
R436
C427 R477
C442
3