Makita 9910 Instruction Manual page 6

ASSEMBLY
Installing or removing abrasive belt
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or removing
the belt.
Pull the lever all the way out and install the
belt over the rollers, then return the lever to
the original position.
CAUTION:
When installing the belt, make sure that the
direction of the arrow on the back of the
belt corresponds
to
the one on the tool
itself.
Adjusting belt tracking
Switch on the tool and make sure that the
belt is aligned properly. If the edge of the
belt extends beyond the edge of the steel
plate or the edge of the belt retracts more
than 8 mm (5/16") away from the edge of
the steel plate, use the adjusting screw to
adjust the belt tracking.
6
I
Steel plate
I
7
more than 8
mm
(Y16")
I
k