Serial Interface - Fujitsu DL3700 Pro User Manual

SERIAL INTERFACE

User's Manual
#D Appendix D
RS-232C is the standard serial interface for data terminal equipment.
The cable connector at the printer side should be a D-subminiature
Cannon or Cinch DB-25P male connector or equivalent that conforms
to EIA standards.
The table that follows shows the pin assignments commonly used by
most computers. In the table:
• "Input" denotes a signal from the computer to the printer.
• "Output" denotes a signal from the printer to the computer.
• The signal level for mark state (logical 1) is -3 V or lower; for
space state (logical 0), it is +3 V or higher.
Pin Signal
No. Name
1 FG
2 TD
3 RD
4 RTS
5 CTS
6 DSR
7 SG
8 CD
11 RC
20 DTR
7
INTERFACE INFORMATION
Direc- Description
tion
– Frame Ground
Output Transmitted Data. This pin carries informa-
tion from the printer to the computer.
Input Received Data. This pin carries information
from the computer to the printer.
Output Request To Send. Spaces are sent when the
printer is ready to transmit data.
Input Clear To Send. Spaces are sent when the
computer is ready to receive data.
Input Data Set Ready. Spaces are sent when the
computer has been powered on and is ready
to receive or transmit data.
– Signal Ground (common return)
Input Carrier Detect. Spaces are sent when the
computer allows the printer to receive data.
Output Reverse Channel. This signal is used instead
of the DTR signal in the RC protocol. Spaces
are sent when the printer is ready to receive
or transmit data.
Output Data Terminal Ready. Spaces are sent when
the printer has been powered on and is ready
to receive or transmit data.
11.08.1998, 23:03 Uhr
D - 7