Wlan Troubleshooting; Wlan Functionality Test Using Sb-7 And Phoenix - Nokia RM-529 Service Manual

RM-529; RM-530; RM-584
BB Troubleshooting and Manual Tuning Guide

WLAN troubleshooting

WLAN functionality test using SB-7 and Phoenix

Steps
1. Place the phone on the SB-7 WLAN test box (see figure below). The co-ordinates are J4 (for the lower
left foot).
2. Start the phone to normal or offline (RF inactive) mode.
3. Search for SB-7 WLAN test box via the phone's WLAN menu. Go to Menu→Ctrl.panel →Connectivity
→WLAN wiz., and the
4. The SB-7 access point is named
default , and then go to Options→Start web browsing. After this, go to
named
Options→Go to New web page. Select Go to without even typing any real web address. If the phone is
in offline mode, select Yes when the question
device cannot connect to the internet through SB-7, but connection to access point default is now
established.
5. Check the signal level from the Connection Manager menu. Go to
Menu→Ctrl.panel→Connectivity→Conn. Mgr. →Active data connections. You should see the
connection in the connection list with the connection time running. Go to Options→Details. Observe the
Signal should show a signal strength Medium (35%) or higher.
signal strength.
Note: The local WLAN environment may affect test results, especially if there are many WLAN access
points nearby and any of them is using the same WLAN channel as SB-7. If you have problems
performing the test, consider repeating the test in a place where local networks do not interfere
with the lower strength signal of the SB-7 box.
Issue 1
Searching for WLAN network pop-up window appears.
default . Connect to the SB-7 access point by selecting the WLAN network
COMPANY CONFIDENTIAL
Copyright © 2009 Nokia. All rights reserved.
Create WLAN connection in offline mode? pops up. The
default
Page 3 –55