Makita BTP131 Instruction Manual page 10

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver/drill/socket bit
004521
Use only the driver/drill/socket bit shown in the figure.
Do not use any other driver/drill/socket bit.
For tool with shallow bit hole
A=12mm Use only these type of bit. Follow the
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For tool with deep bit hole
A=17mm
To install these types of bits, follow
the procedure (1).
B=14mm
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
011405
1. To install the bit, pull the sleeve and insert the bit
into the sleeve as far as it will go. Then release
the sleeve to secure the bit.
1
2
012234
2. To install the bit, insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
1. Bit
2. Sleeve
10
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
1
2
3
012235
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
CAUTION:
Do not touch the drill bit shortly after operating as it
•
gets hot. Replace the drill bit after cooling it down.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
Hook (Optional accessory)
012236
CAUTION:
When installing the hook, tighten the screw firmly.
•
Failure to do so may cause the breakage of the
tool or personal injury.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
1. Bit
2. Bit-piece
3. Sleeve
1. Groove
2. Hook
1
3. Screw
2
3