Functional Description - Makita 9227CB Instruction Manual

Hide thumbs Also See for 9227CB:

Instruction manual (45 pages)

Instruction manual (41 pages)

Instruction manual (25 pages)

Table of Contents

13. Regularly clean the power tool's air vents. The

motor's fan will draw the dust inside the housing

and excessive accumulation of powdered metal

may cause electrical hazards.

14. Do not operate the power tool near flammable

materials. Sparks could ignite these materials.

15. Do not use accessories that require liquid

coolants. Using water or other liquid coolants

may result in electrocution or shock.

Kickback and Related Warnings

Kickback is a sudden reaction to a pinched or snagged

rotating wheel, backing pad, brush or any other

accessory. Pinching or snagging causes rapid stalling of

the rotating accessory which in turn causes the

uncontrolled power tool to be forced in the direction

opposite of the accessory's rotation at the point of the

binding.

Kickback is the result of power tool misuse and/or

incorrect operating procedures or conditions and can be

avoided by taking proper precautions as given below.

a) Maintain a firm grip on the power tool and

position your body and arm to allow you to

resist kickback forces. Always use auxiliary

handle, if provided, for maximum control over

kickback or torque reaction during start-up. The

operator can control torque reactions or kickback

forces, if proper precautions are taken.

b) Never place your hand near the rotating

accessory. Accessory may kickback over your

hand.

c) Do not position your body in the area where

power tool will move if kickback occurs.

Kickback will propel the tool in direction opposite to

the wheel's movement at the point of snagging.

d) Use special care when working corners,

sharp edges etc. Avoid bouncing and snagging

the accessory. Corners, sharp edges or bouncing

have a tendency to snag the rotating accessory

and cause loss of control or kickback.

e) Do not attach a saw chain woodcarving blade

or toothed saw blade. Such blades create

frequent kickback and loss of control

Safety Warnings Specific for Polishing Operations:

a) Do not allow any loose portion of the

polishing bonnet or its attachment strings to

spin freely. Tuck away or trim any loose

attachment

strings.

attachment strings can entangle your fingers or

snag on the workpiece.

Additional Safety Warnings:

16. Do not leave the tool running. Operate the tool

only when hand-held.

Loose

and

spinning

17. Always be sure that the tool is switched off

and unplugged or that the battery cartridge is

removed before carrying out any work on the

tool.

18. Check

that

supported.

19. If working place is extremely hot and humid, or

badly polluted by conductive dust, use a

short-circuit breaker (30 mA) to assure

operator safety.

20. Do not use the tool on any materials

containing asbestos.

21. Do not use water or grinding lubricant.

22. Ensure that ventilation openings are kept clear

when working in dusty conditions. If it should

become

necessary

disconnect the tool from the mains supply

( use non metallic objects ) and avoid

damaging internal parts.

SAVE THESE INSTRUCTIONS.

WARNING:

DO NOT let comfort or familiarity with product

(gained from repeated use) replace strict adherence

to safety rules for the subject product. MISUSE or

failure to follow the safety rules stated in this

instruction manual may cause serious personal

injury.