Makita 2414db Instruction Manual page 9

When cutting workpieces over 65 m m
(2-9/16") wide at an angle, attach a straight
piece
of
wood (spacer) over
190 mm
(7-1/2") long x 45 mm (1-3/4") wide to the
guide plate as shown in the figure. Attach
this spacer with screws through the holes
in the guide plate.
If you use a spacer block which is slightly
narrower than the workpiece as shown
in
the figure, you can also utilize the wheel
economically.
Long workpieces must be supported by
blocks of non-flammable material on either
side so that it will be level with the base
top.
Diameter of
workpiece
Width of
spacer block
A
9