Jump-Starting - Yamaha YX10ZPSG Owner's Manual

To install the battery
TIP
Be sure the battery is fully charged.
1. Place the battery in its compartment.
2. Connect the positive battery lead first,
then the negative battery lead by install-
ing their bolt. NOTICE: When installing
the battery, the main switch must be
off, and the positive lead must be con-
nected before the negative lead.
3
2
1. Positive battery lead (red)
2. Negative battery lead (black)
3. Battery
3. Install the battery holding plate by install-
ing the bolts.
4. Install the panel.
EBU35243

Jump-starting

Jump-starting the vehicle should be avoided.
The battery should be removed and charged
instead.
EWB03430
WARNING
To avoid battery explosion and/or serious
[ECB01111]
damage to the electrical system:
 Do not connect the negative lead of the
jumper cable to the negative terminal of
the battery.
 Do not touch the positive lead of the
1
jumper cable to the negative lead.
 Do not reverse the polarity of the jumper
cables when connecting to the batteries.
However, if the vehicle must be jump-started,
proceed as follows.
1. Turn the key to "
8-58
" (off).
8