Page 1
Demolition Hammer MODEL HM0860C 004479 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
8JD, ENGLAND Power supply Responsible manufacturer: Makita Corporation Anjo Aichi Japan The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They...
GENERAL SAFETY RULES GEA001-3 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery- operated (cordless) power tool.
20. Maintain power tools. Check for misalignment or ditions and the work to be performed. Use of the binding of moving parts, breakage of parts and power tool for operations different from those any other condition that may affect the power intended could result in a hazardous situation.
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 004480 O(OFF) I(ON) CAUTION: • Before plugging in the tool, always check to see that the tool is switched off.
Page 6
ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. For tool with side grip (auxiliary handle) 004483 The side grip swings around to either side, allowing easy handling of the tool in any position.
Insert the bit into the tool. Turn the bit and push it in until it engages. 004484 If the bit cannot be pushed in, remove the bit. Pull the chuck cover down a cou- ple of times. Then insert the bit again. Turn the bit and push it in until it engages.
004490 packed lubrication system. It should be relubricated after every 6 months of operation. Send the complete tool to Makita Authorized Service Center for this lubrication service. However, if circumstances require that you should lubricate it by yourself, proceed as follows.
Page 9
Whenever reinstalling the handle, use the two short screws for the upper side and two long screws for the lower side. To maintain product SAFETY and RELIABILITY, repairs, any other mainte- nance or adjustment should be performed by Makita Authorized Service Cent- ers, always using Makita replacement parts. 1. Terminal...
Page 10
CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.