Installation - Zanussi ZGG75524 User Manual

• Disconnect the appliance from the elec-
trical supply, before you do the mainte-
nance work or you clean it.
• The electrical mains terminal is live.
• Make electrical mains terminal free of volt-
age.
• Install correctly to give anti-shock protection.
• A loose and incorrect mains plug and socket
connections can make the terminal become
too hot.
• A qualified electrician must install the clamp-
ing connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and
replace the damaged mains cable with appli-
cable cable. Speak to your local Service
Force Centre.
• The appliance must have the electrical instal-
lation which lets you disconnect the appli-
ance from the mains at all poles with a con-
tact opening width of minimum 3 mm.

Installation

Warning! The following instructions about
installation, connection and maintenance
must be carried out by qualified personnel in
compliance with standards and local
regulations in force.
Gas Connection
It is necessary that the connection to the gas
mains are carried out by means of an AGB tap.
Choose fixed connections or use a flexible pipe
in AGB (stainless steel) in compliance with the
regulation in force. If you use flexible metallic
pipes, be careful they do not come in touch
with mobile parts or they are not squeezed. Al-
so be careful when the hob is put together with
an oven.
The connection must be done according to
regulation NBN D 5I.003.
Important! Make sure that the gas supply
pressure of the appliance obeys the
recommended values. The adjustable
connection is fixed to the comprehensive ramp
by means of a threaded nut G 1/2". All the
www.zanussi.com
• If the fixing bracket is near to the terminal
block, always make sure the connection ca-
ble does not come in contact with the edge
of the bracket.
• You must have correct isolation devices: line
protecting cut-outs, fuses (screw type fuses
removed from the holder), ground leakage
trips and contactors.
Disposal of the appliance
• To prevent the risk of physical injury or dam-
age
– Disconnect the appliance from the power
supply.
– Cut off the mains cable where it connects
with the appliance and discard it.
– Flat the external gas pipes if there are fit-
ted.
– Speak to your local authorised facilities for
disposal of your appliance.
components shown in the figure have already
been assembled in the factory. The appliance,
before leaving the factory, has been tested in
order to give you the best results.
1
2
3
End of shaft with nut
1
Washer
2
Elbow
3
Liquid gas: use the rubber pipe holder. Always
engage the gasket. Then continue with the gas
17