Download
Share
Print this page
  1. Manuals
  2. Brands
  3. TallyGenicom Manuals
  4. All in One Printer
  5. 6312
  6. Installation instructions manual

TallyGenicom 6312 Installation Instructions Manual

Hide thumbs Also See for 6312:

Advertisement

Quick Links

Download this manual See also: Maintenance Manual, Operator's Manual
6306 / 6312
Unpacking/Installation

Advertisement

loading

Related Manuals for TallyGenicom 6312

Summary of Contents for TallyGenicom 6312

  • Page 1 6306 / 6312 Unpacking/Installation...
  • Page 2 Unpacking Step 1. Cut the shipping bands. Step 2. Open the top of the box and remove the accessories and the foam end caps. Step 3. Lift the cardboard box off the printer. Steps 4 & 5. Using a 9/16" socket wrench, remove two bolts. Step 6.
  • Page 3 Shipping Hardware Removing the Shipping Hardware There are 4 screws, identified by red tags, that secure the printer base to the inside mechanism. The upper 2 shipping screws have wing-heads which tighten a bracket against the platen. The lower 2 shipping screws fasten from underneath, near the front of the printer cabinet.
  • Page 4 Installing Rear Paper Guide The Rear Paper Guide has two parts. Separate them and attach the lower part to the back of the printer with two existing Phillips-head screws. Setting Up Paper Stacking Chains Paper exits the print area through a set of passive Paper Stacking Chains that help fold and stack printed forms uniformly.
  • Page 5 Interface and Power Connections Serial/Parallel The serial interface operates up to 38.4 kBaud and uses a standard DB-25 serial cable connector and standard RS-232-C signals. The Centronics parallel port is IEEE-1284 compliant and uses a 36-pin 1284-B type connector (AMP 555119-1 or equivalent). To connect the Serial or Parallel I/O cable, plug in the cable to the proper connector on the I/O panel.

  • Page 6: Installing The Ribbon

    Installing the Ribbon Step 1. Make sure the printer is Offline or power is off. Open the printer lid. Step 2. Remove slack in the ribbon by turning the knob on the ribbon cartridge as indicated by the arrow next to the knob, then slip the ribbon, left side first, over the two ribbon guides and between the front and rear panels of the ribbon shield on the printer.

  • Page 7: Loading Paper

    Loading Paper Step 1. Raise the printer lid and open the doors on both tractors. Step 2. Place the stack of paper inside the cabinet on the floor and feed the paper up through the paper slot, a little ways past the tractors and through the gap between the top back of the printer and the lid.
  • Page 8 Step 4. The Column Alignment Scale is on the top of the hammer bank housing. Column 1 of pre-printed forms or the left-hand perforation of plain paper should be aligned with the mark on the scale the forms creator has designated. Step 5.
  • Page 9 Step 6. Set the Top of the Form (TOF). This is done from the Control Panel. If the printer is not on, turn it on now. Press the Online key until "Offline" is displayed. Use the up or down arrows to move the perforation line on the paper to be aligned with the nubbin on the tractor door.

  • Page 10: Testing The Printer

    Testing the Printer You can use the Help Menu printout to test the printer. How to Print a Help Menu Printout The organization of the multilevel menus is shown on the Help Menu printout. All current selections are marked with an asterisk. 1.

This manual is also suitable for:

6306