Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for D-Link mydlink DCH-S220
Summary of Contents for D-Link mydlink DCH-S220
- Page 1 Version 1.01 | July 7, 2015 User Manual mydlink™ Wi-Fi Siren DCH-S220...
-
Page 2: Preface
Preface D-Link reserves the right to revise this publication and to make changes in the content hereof without obligation to notify any person or organization of such revisions or changes. Manual Revisions Revision Date Description 1.00 June 1, 2015 • First version 1.01... -
Page 3: Table Of Contents
Hardware Overview ..............4 Front/Bottom ................. 4 Side .................... 5 Wireless Installation Factors ............. 6 Setting Up Your Device ............... 7 mydlink™ Home ..............9 My Devices ..................9 Information ...................10 My Actions ..................11 My Places ..................14 D-Link DCH-S220 User Manual... -
Page 4: Product Overview
Section 1 - Product Overview Product Overview Package Contents DCH-S220 mydlink™ Wi-Fi Siren Quick Installation Card Quick Install Card General Public License (GPL) Statement If any of the above items are missing from your package, please contact your reseller. D-Link DCH-S220 User Manual... -
Page 5: System Requirements
Mobile Requirements • iPhone, iPad, or Android smartphone or tablet • For mydlink and mydlink app requirements mydlink Requirements refer to: http://www.mydlink.com Please refer to the mobile app’s store page to check whether your device is compatible. D-Link DCH-S220 User Manual... -
Page 6: Introduction
Works With Other D-Link Connected Home Devices The mydlink™ Wi-Fi Siren can be triggered by other D-Link Connected Home devices such as a water sensor, door sensor, and smoke detector, so you can customize your own home automation system to suit your purposes. -
Page 7: Hardware Overview
Section 1 - Product Overview Hardware Overview Front/Bottom Blinking Red The siren has been triggered Warning LED Light Off The siren has not been triggered Speaker Alarm sounds when triggered Electrical Plug Plugs into an electrical wall outlet D-Link DCH-S220 User Manual... -
Page 8: Side
Press the WPS button for 1 second to connect the siren to your wireless router using Wi-Fi Protected Setup. Reset Button Press the reset button for 5 seconds to reset the DCH-S220 back to the factory default settings. D-Link DCH-S220 User Manual... -
Page 9: Wireless Installation Factors
2.4 GHz phone base is as far away from your wireless devices as possible. The base transmits a signal even if the phone in not in use. 6. If you are using X-10 wireless products, such as ceiling fans, lights, and home security systems, your wireless connection may degrade dramatically. D-Link DCH-S220 User Manual... -
Page 10: Setting Up Your Device
Add New Device, and follow the instructions. Step 4: When you are asked to scan a QR code, use the code on the Quick Install Card in your package, or on the label attached to your device. D-Link DCH-S220 User Manual... - Page 11 In order for notifications to work, you must set up a rule first using the mydlink Home app’s My Actions page. Please refer to page 11 for details on how to set up a rule. Congratulations, your DCH-S220 is now ready to use! D-Link DCH-S220 User Manual...
-
Page 12: Mydlink™ Home
More details are on the next page. To change the device name or associated icon, tap the name or the icon respectively, and enter the new name or use the menu to select a new icon. D-Link DCH-S220 User Manual... -
Page 13: Information
Displays the MAC address of the device. IP Address: Displays the IP address of the device. mydlink Displays the mydlink number of the device. Number: Remove Tap Remove to perform a factory reset and remove Device: the device from your mydlink account. D-Link DCH-S220 User Manual... -
Page 14: My Actions
2. Tap on the device (sensor) you want to trigger the siren with. 3. Select from the available events for this device and tap Next. Whenever the selected event occurs, the siren will be triggered. 4. Select your DCH-S220 from the list to be the responder. D-Link DCH-S220 User Manual... - Page 15 6. In the text box, type in a name for this rule and tap Done. 7. The new rule will appear on the My Actions page and you can now enable and disable your rule from this page. D-Link DCH-S220 User Manual...
- Page 16 8. To delete a rule on iOS, swipe the rule you want to delete to the left. Tap the red Delete button to remove the rule. To delete a rule on Android, swipe the rule you want to delete to the right. Tap the trash can icon to remove the rule. D-Link DCH-S220 User Manual...
-
Page 17: My Places
Tap next to it to enter a name for the group. Then tap the + icon to add devices to the group. 3. Select the devices to be included in this group and tap Done. D-Link DCH-S220 User Manual... - Page 18 Section 3 - Usage 4. Your group will be created and will show up in My Places. Tap a device to take you to its settings. D-Link DCH-S220 User Manual...
-
Page 19: Troubleshooting
For some users, the notifications may be delayed temporarily because it takes some time to optimize the notification system. In this case, we recommend restarting the app and trying again after 10-30 minutes. * The DCH-S220 must be connected to your home Wi-Fi network for remote access. D-Link DCH-S220 User Manual... -
Page 20: Technical Specifications
• 105 grams (3.70 ounces) Diagnostic LEDs • Status • Warning Operating Temperature • 0 to 40 ˚C (32 to 104 ˚F) Storage Temperature • -20 to 65 ˚C (-4 to 149 ˚F) Frequency range varies depending on local regulations D-Link DCH-S220 User Manual... -
Page 21: Safety Instructions
D-Link may result in the loss of product warranty. Unless expressly approved by an authorized representative of D-Link in writing, you may not and may not permit others to: • Disassemble or reverse engineer the device or attempt to derive source code (underlying ideas, algorithms, or structure) from the device or from any other information provided by D-Link, except to the extent that this restriction is expressly prohibited by local law. - Page 22 • Install the power supply before connecting the power cable to the power supply. • Unplug the power cable before removing the power supply. • If the system has multiple sources of power, disconnect power from the device by unplugging all power cables from the power supplies. D-Link DCH-S220 User Manual...
- Page 23 • Always unplug the power before cleaning this device. • Do not use liquid or aerosol cleaners of any kind. Use only compressed air that is recommended for electronic devices. • Use a dry cloth for cleaning. D-Link DCH-S220 User Manual...
- Page 24 • When transporting a sensitive component, first place it in an antistatic container or packaging. • Handle all sensitive components in a static-safe area. If possible, use antistatic floor pads, workbench pads, and an antistatic grounding strap. D-Link DCH-S220 User Manual...
- Page 25 D-Link recommends that you always switch off or unplug your D-Link products when they are not in use. By doing so you will help to save energy and reduce CO2 emissions.
-
Page 26: Contacting Technical Support
• Hardware Revision (located on the label on the device (e.g., rev A1)) • Serial Number (s/n number located on the label on the device). You can find software updates and user documentation on the D-Link website as well as frequently asked questions and answers to technical issues. -
Page 27: Warranty
Any repair or replacement will be rendered by D-Link at an Authorized D-Link Service Office. The replacement hardware need not be new or have an identical make, model or part. D-Link may, at its option, replace the defective Hardware or any part thereof with any reconditioned product that D-Link reasonably determines is substantially equivalent (or superior) in all material respects to the defective Hardware. - Page 28 Software or to refund the portion of the actual purchase price paid that is attributable to the Software. Except as otherwise agreed by D-Link in writing, the replacement Software is provided only to the original licensee, and is subject to the terms and conditions of the license granted by D-Link for the Software.
- Page 29 • The customer must submit with the product as part of the claim a written description of the Hardware defect or Software nonconformance in sufficient detail to allow D-Link to confirm the same, along with proof of purchase of the product (such as a copy of the dated purchase invoice for the product) if the product is not registered.
- Page 30 Purolator Canada or any common carrier selected by D-Link. Return shipping charges shall be prepaid by D-Link if you use an address in Canada, otherwise we will ship the product to you freight collect. Expedited shipping is available upon request and provided shipping charges are prepaid by the customer.
-
Page 31: Limitation Of Liability
FOR WARRANTY SERVICE) RESULTING FROM THE USE OF THE PRODUCT, RELATING TO WARRANTY SERVICE, OR ARISING OUT OF ANY BREACH OF THIS LIMITED WARRANTY, EVEN IF D-LINK HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. THE SOLE REMEDY FOR A BREACH OF THE FOREGOING LIMITED WARRANTY IS REPAIR, REPLACEMENT OR REFUND OF THE DEFECTIVE OR NONCONFORMING PRODUCT. - Page 32 The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user. D-Link DCH-S220 User Manual...
- Page 33 Les conditions de fonctionnement sont sujettes à deux conditions: (1) Ce périphérique ne doit pas causer d’interférence et. (2) Ce périphérique doit accepter toute interférence, y compris les interférences pouvant perturber le bon fonctionnement de ce périphérique. D-Link DCH-S220 User Manual...
-
Page 34: Registration
Appendix E - Registration Registration Product registration is entirely voluntary and failure to complete or return this form will not diminish your warranty rights. Version 1.01 July 7, 2015 D-Link DCH-S220 User Manual...