Product Description - Buffalo GH227 Instruction Manual

UK
Safety Tips
Position on a flat, stable surface
A service agent / qualified technician should carry out installation and any repairs if required.
Do not remove any components or service panels on this product
Consult Local and National standards to comply with the following:
o
Health and safety at work legislation
o
BS EN Codes of practice
o
Fire Precautions
o
IEE wiring regulations
o
Building regulations
DO NOT use jet / pressure washers to clean the appliance
DO NOT use the appliance outside
DO NOT use the appliance to store medical supplies
DO NOT use electrical appliances inside the appliance (e.g. heaters, ice-cream makers etc)
DO NOT allow oil or fat to come into contact with the plastic components. Clean immediately if contact occurs
DO NOT store products on top of the appliance
Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance
Always switch off and disconnect the power supply to the unit before cleaning
Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities
If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order
to avoid a hazard
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the
use of the appliance by a person responsible for their safety
Children should be supervised to ensure that they do not play with the appliance

Product Description

GH227 Buffalo 5.7L Cylindrical Soup Kettle
Pack Contents
Body Assembly
Top Ring
Installation
Remove all packaging and dispose of safely. Wash Liner, Top Ring and Lid in warm soapy water, rinse in clean water then dry
thoroughly.
Operation
Place the plug in the electric socket to connect electricity.
Partly fill the Body with water, place the Liner inside the Body, then place the Top Ring over the lip of the Liner to secure in place.
Pour the hot soup or food in to the Liner, then position the Lid on the Top Ring. Switch on electricity at socket. Start heating by
rotating the control knob clockwise, indicator light will come on and stay on until holding temperature selected is reached. Power
will come on to start heating again when the temperature of the kettle falls.
Kettle Liner
Lid Assembly