Free Motion Quilting Foot; Walking Foot - Brother 884-T78 Operation Manual

Free Motion Quilting Foot

Reduce the foot pressure and turn
the dial on the machine lowering the
feed dog for free motion quilting.
Note
• If the foot is frequently used, be
sure to apply a small amount of
oil about once a month to the
area indicated by the arrows. (If
too much oil is applied, wipe off
the excess with a cloth.)
• For best results when using
metallic or monofilament
threads for free motion quilting,
sew with a good quality thread,
set upper tension 1-2, and use
a metallic needle.

Walking Foot

Note
• Do not press the foot controller
all the way down.
Try to keep the sewing speed
low (500 r.p.m. or less).
• The fabric may not feed
properly if you sew at high
speeds.
• The feed dog for feeding the
cloth may not move if the foot
pressure on the fabric is too
strong. Use the presser foot
pressure adjustment dial to
achieve the desired results.
• It is not advisable or necessary
to use the Pin Feed mode with
the walking foot.
Insert the forked part of the
1
operation lever, while raised in
an upright position, onto the
screw on the right side of the
needle bar, as shown and then
insert the cap screw.
Tighten the screw securely
2
with a screwdriver. Tightening
adequately is important as the
screw might loosen due to the
foot and forked operation lever
vibration.
Forked part
of operation
1
lever
Secure the
cap screw
2
with a
screwdriver.
23