NEC NP60 User Manual page 29

Adjust the Tilt Foot
1. Lift the front edge of the projector.
CAUTION:
Do not try to touch the ventilation outlet during Tilt Foot adjust-
ment as it can become heated while the projector is turned on and
during its cool down period after it is turned off.
2. Push up and hold the Adjustable Tilt Foot Button on the front
of the projector to extend the adjustable tilt foot (maximum
height).
3. Lower the front of the projector to the desired height.
4. Release the Adjustable Tilt Foot Button to lock the adjustable
tilt foot.
There is approximately 10 degrees (up) of adjustment for the front
of the projector.
Adjusting the height of a projected image or changing the projec-
tion angle will result in the Auto Keystone function quickly cor-
recting the vertical distortion.
CAUTION:
Do not use the tilt-foot for purposes other than originally intended.
Misuses such as using the tilt foot to carry or hang (from the wall or
ceiling) the projector can cause damage to the projector.
NOTE: The rear foot height can be adjusted up to 0.16 inch/4 mm (1 degree of
angle). Rotate the rear foot to the desired height in order to square the image
on the projection surface. Do not extend the rear foot over 0.16" (4 mm). Do-
ing so will cause the rear foot to come free off the bottom.
3. Projecting an Image (Basic Operation)
1
Adjustable Tilt Foot
Rear foot
Up
21
Adjustable Tilt
Foot Button
2
Ventilation (outlet)
3
PC
C O
N TR
O L
C O
M PU
TE
R IN
VI D
EO
IN
S- VI
D EO
IN
A C
IN
Down