Specifications - Makita LH1040 Original Instruction Manual

58-2. Brush holder cap

SPECIFICATIONS

Model
Blade diameter
Hole diameter
For all countries other than European countries
For European countries
Max. Cutting capacities (H x W) with blade 260 mm in diameter in the miter saw mode
Bevel angle
0°
45° (left)
Max. Cutting capacities at 90°in the table saw (bench saw mode)
-1
No load speed (min )
Table size (W x L)
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
･
When using the tool in the miter saw
mode, secure the top table at the
topmost position so that the saw blade
never protrudes from the top surface of
the top table.
･
Do not place hand or fingers close to
the blade.
･
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
69 mm x 130 mm
93 mm x 95 mm
35 mm x 130 mm
53 mm x 95 mm
END208-4
equipment and
Miter angle
0°
Intended use
The tool is intended for accurate straight cutting and
(only when used as a miter saw on the lower table) miter
cutting in wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted noise level determined according
to EN61029:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration emission value determined according to
EN61029 :
its
Vibration emission (a
Uncertainty (K) : 1.5 m/s
7
LH1040 / LH1040F
25.4 mm and 25 mm
45°
right 69 mm x 85 mm, 93 mm x 67 mm
left 69 mm x 85 mm, 93 mm x 67 mm
right 35 mm x 91 mm, 49 mm x 67 mm
left 35 mm x 65 mm, 49 mm x 42 mm
260 mm x 405 mm
530 mm x 476 mm x 535 mm
have reached the end of their life must
be collected separately and returned to
an environmentally
recycling facility.
) : 92 dB(A)
pA
) : 105 dB(A)
WA
Wear ear protection
2
) : 2.5 m/s or less
h
2
255 mm -260 mm
30 mm
40 mm
4,800
14.3 kg
/II
compatible
ENE060-1
ENF002-1
ENG102-3
ENG238-1