Assembly And Adjustments - DeWalt DCS355 Instruction Manual

This oscillating multi-tool isa professional power tool.DONOT let
children come into contact with the tool. S upervision isrequired when
inexperienced operators use this tool.
ASSEMBLY AND ADJUSTMENTS
A WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
A WARNING: Risk of lacerations or burns. Do not touch the
sharp edges of accessories at any time. Do not touch workpiece
or blade immediately after operating the tool. They can become very
hot. Handle carefully. Always allow accessories and workpiece to
cool before handling.
installing/Rernovin9 Accessories
(Fig. 3-5)
TOOL-FREE ACCESSORY CLAMP
The DC3355 features a quick change accessory system. This allows
for faster accessory changes without the need for wrenches or hex
keys like other oscillating tool systems.
1. Grasp the tool and squeeze the FIG._
accessory clamping lever (C) as
shown in Figure 3.
2. Clean any residual debris from the
tool shaft and the accessory holder.
3. Slide the accessory between the
shaft (J) and the accessory holder
making sure the accessory engages
all eight pins on the holder and is
_J
flush with the shaft.
4. Release the accessory clamp lever.
NOTE: Some accessories, such as scrapers and blades, can be
mounted at an angle if required as shown in Figure 5.
FIG.4 FIG.5
INSTALLING/REMOVING SANDING SHEETS (FIG. 6)
A diamond shaped platen uses a hook FIG.6
and loop adhesion system to attach the
sanding sheets. The platen allows you L
to use it on large flat surfaces and tight
spots or corners.
1. Attach the sanding platen (K) as
described under Installing/
Removing Accessories.
2. Align the edges on the sanding
sheet, with the edge of the sanding
platen and press the sanding sheet
(L) onto the platen.
10