Table of Contents
Advertisement
Chapter 5
Page 5-12
The setting screen is displayed. The current setting is displayed.
MLP Speed
LSD speed
Serial port setting
User port speed :
T120 port speed :
Console speed
Console parity
Press ENTER after choosing.
MLP:
Multi Layer data sets the speed for NEC far-end control.
Note: MLP must be active in order to upgrade VL system
LSD:
Serial port setting:
Sets the type of control to be activated on the serial port.
User port speed:
environment.
T120 port speed:
environment.
Console speed:
connected to the VisuaLink serial port.
Console parity:
be connected to the VisuaLink serial port.
Note 1: To select an item use the up and down portion of the CAMERA
CONTROL button.
Note 2: To change a setting use the left and right portion of the CAMERA
CONTROL button to toggle through the item.
Note 3: Appendix A is a table detailing MLP to LSD speed setting relationship.
Press ENTER button to define after changing a setting.
Press the MENU and CANCEL button three (3) times to proceed back to the
video image.
:
< 4.0kb/s >
:
< 1.2kb/s >
Port 1
:
< Camera >
Port 2
:
< Console >
<
9.6kb/s >
< 38.4kb/s >
:
<
9.6kb/s >
:
< 8 bit none >
on-line.
Low Speed data sets the speed for far-end camera control.
Sets the data transmission rate for a point-to-point
Sets the data transmission rate for a multipoint
Sets the baud speed for a terminal which might be
Sets the parity and data length for a terminal which might
VisuaLink 128/384 User Guide
NDA-24230 Issue 2.0
Advertisement
Table of Contents
