Step 1 - Gathering Information - Buffalo AirStation WHR-HP-G54 Quick Setup Manual

Step 1 - Gathering Information

Depending on the type of broadband internet service you are subscribed to, different
pieces of information may be needed to complete the setup. In particular, most
DSL providers require PPPoE information to log in to your connection. Call your
internet service provider's customer or technical support number to fi nd if any special
information is required for you to connect to the internet.
Recording the AirStation's LAN MAC Address
Before you place your AirStation, it's a good idea to record its LAN MAC address.
This will be the default SSID of your wireless network. You can fi nd the LAN MAC
address on the bottom of the AirStation.
MAC Addresses are 12-digit codes comprised of numbers and letters. When
inputting MAC Addresses for custom confi gurations, a semi-colon (:) is used to
separate every two digits. ex: 00:07:40:00:00:00
The Auto/Bridge Switch on the bottom of the AirStation is used to determine its
functionality. When set to Auto, Router mode or Bridge mode can be selected from
within the confi guration screens. As default the AirStation is in Router mode. However
by fl icking the switch to Bridge mode the AirStation becomes a dedicated bridge.
The default IP Address of the AirStation differs depending on which mode it is set to.
In Router mode the default IP Address is 192.168.11.1 whereas in Bridge mode the
default IP Address is 192.168.11.100.
2