Advertisement
REPLACING MIC CORD
Removing Cord from Mic Body
1.
Refer to illustration on next page. Grasp
locking collar and, while pushing it firmly
towards Mic body, turn it counterclock-
wise 1/4 turn to disengage it from Mic
body.
2.
Disconnect cord from Mic body by
pulling TELCO connector (which has no
tab on it) out of TELCO jack on circuit
board inside Mic body.
Installing Cord Into Mic Body
1.
Slide locking collar on Mic end of cord
away from TELCO plug and past strain
relief on cord.
2.
Orient TELCO plug on Mic end of cord
so that it aligns with TELCO jack inside
Mic body and its contacts face rear of
Mic housing.
3.
Pass TELCO plug through hole at
bottom of Mic body and plug it into
TELCO jack on circuit board inside Mic
body.
4.
Slide locking collar back up on cord with
tabs on its sides facing sides of Mic
body.
5.
Push locking collar firmly into hole at
bottom of Mic body then turn it 1/4 turn
clockwise to secure it in place.
5
Advertisement
