Advertisement
27" Domestic Dryer⎯Technical Information
MDE6700A*, MDG6700A*
• Due to possibility of personal injury or property damage, always contact an authorized technician for servicing or
repair of this unit.
• Refer to Service Manual 16026446 for detailed installation, operating, testing, troubleshooting, and disassembly
instructions.
All safety information must be followed as provided in Service Manual 16026446.
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before servicing, unless
testing requires power.
September 2006
©2006 Maytag Services
!
CAUTION
!
WARNING
1
16026881
RPL 16026540
Advertisement
Table of Contents
Related Manuals for Maytag MDE6700A Series
Summary of Contents for Maytag MDE6700A Series
- Page 1 All safety information must be followed as provided in Service Manual 16026446. WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before servicing, unless testing requires power. September 2006 16026881 RPL 16026540 ©2006 Maytag Services...
-
Page 2: Troubleshooting Procedures
• Clothes too wet due to insufficient spin out by • Hi-Limit trips easily or is open. washer. • Regulating thermostat trips easily or is open. • Membrane switch open. • Check Thermistor. September 2006 16026881 RPL 16026540 ©2006 Maytag Services... -
Page 3: Service Mode
The following table lists the various tests available Fahrenheit. while in the Service Mode. Before advancing to the next test, the current test running must be terminated. Press the following keys to access: September 2006 16026881 RPL 16026540 ©2006 Maytag Services... -
Page 4: Diagnostic Code
Once an initial direction is selected by the user (either function, replace Clockwise or Counterclockwise), subsequent machine control movements of the knob in the same direction will board. show older codes. If the user changes direction and 16026881 September 2006 RPL 16026540 ©2006 Maytag Services... - Page 5 • Thermostat 2 resistance < 1Ω (Blue & Black wire) -If resistance is infinity, replace thermostat 2. • Heater resistance 10 Ω (Blue & Blue wire) -If resistance is infinity, replace Heater. September 2006 16026881 RPL 16026540 ©2006 Maytag Services...
- Page 6 Resistance across terminal indicates a closed switch TH2 Hi-Limit (Gas) 120V/10W(E12) • Belt Cut-off S/W - Lever open : Resistance value < 1Ω - Lever push : Resistance value Less than 1 ohm 16026881 September 2006 RPL 16026540 ©2006 Maytag Services...
- Page 7 190 Ω ± 10% with wet clo Cycling Thermostat - Disconnect harness and test Blue wire Pin 2 to Red wire Pin 6. Approx 10 K Ω at 25 °C 77° F. September 2006 16026881 RPL 16026540 ©2006 Maytag Services...
-
Page 8: Wiring Schematic
Wiring Schematic WARNING To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer before servicing, unless testing requires power. 16026881 September 2006 RPL 16026540 ©2006 Maytag Services... - Page 9 Wiring Schematic WARNING To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer before servicing, unless testing requires power. September 2006 16026881 RPL 16026540 ©2006 Maytag Services...