Installing And Configuring The Acl Tape Drive For The Nonstop S-Series Server; Installation Procedure For New Model - HP N1528A Installation And User Manual

3
Installing and Configuring the
ACL Tape Drive for the NonStop S-
Series Server
This section includes these topics:

Installation Procedure for New Model

Installation Procedure for Old Model
Configuration
Note. These ACL units are now shipped in a different type of chassis. The installation
procedure for the newer model is different from the older model. If you have the newer model,
please see Installation Procedure for New Model
installation procedure for the older model see
configuration section applies to both types.
Installation Procedure for New Model
1. Check that the power switch on the tape drive is set to the off position. See
Figure 3-1.
2. Connect the power cord to the tape drive's AC power receptacle. See
3. Make sure the power cord is fully seated.
Note. Do not attach the male end of the power cord to a power outlet at this time.
N1528A and N1529A ACL Tape Drive Installation and User's Guide—544594-003
3-1
3-5
3-9
for the installation procedure. For the
Installation Procedure for Old
3 -1
Model. The
Figure 3-1.