Table of Contents
Advertisement
Basic setting
The information of model is controlled by the indoor unit and
can not be changedas is the same to capacity information.
Normal fan
The default information is controlled by the indoor unit.
Basic Setting
Auto fan
Auto fan
Normal
Quiet fan
fan
unit
6
Breeze
High speed fan
Super fan
Return
Mode selection
Different mode combinations can be set according to each
application.
Basic Setting
Auto Heat Dry Cool Fan
Dry Cool Fan
Heat Dry Cool Fan
Mode
Cool Heat Fan
selection
Auto Bypass Recovery
Heat only
Hot water
Return
New/old protocol
Self-adaption is default. The function is used for basic
settings. Do not reset it,or the controller may not work
normally.
Power off memory
If the function is set on, the wired controller will maintain the
previous state in temperature, fan speed ,etc from in outage
to power up again.
Master/Slave set
Wired controller can be set as master controller or slave
controller through this function. Slave controller can only
control some of the functions.
Basic Setting
Outdoor fan
fixed speed
Power off
memory
Master/Slave
set
Return
Ambient temperature revision
The revision value is only valid for wired controller ambient
temperature. Press enter key to make the arrows static and
adjust the temperature using the Left/Right key.
Basic Setting
Ambient temp.
revision
Twin energy
judgement
condition
Return
10:30
Thursday
01.01.2015
AM
1
2
3
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Enter
Main
10:30
Thursday
01.01.2015
AM
Enter
Main
10:30
Thursday
01.01.2015
AM
grade
rotational speed
ON
OFF
Master
Slave
Enter
Main
10:30
Thursday
01.01.2015
AM
- 3.5 º F
ON
OFF
1 group
2 group
3 group
4 group
Enter
Main
WIRED CONTROLLER
Indoor temperature collection
The ambient temperature may be read from the wired
controller or the indoor unit through this setting. The same for
indoor humidity reading.
Basic Setting
Indoor hum.
collection
Indoor temp.
unit
collection
6
Wifi module
Return
In basic setting interface, press Up/Down key to adjust
unit number; press Left/Right key to move the cursor.
Some functions are not available for some models and the
information is gray.
ECO
NOTE: The energy saving default parameters are listed below:
74°F Lowest temperature limit of Cooling and Dry mode.
78°F Highest temperature limit of Heating mode.
74°F – 86°F Temperature adjustment range in Cooling and Dry
mode.
Four direction keys can move the cursor, when the arrows
flash, press enter key to stop the flashing and press Left/
Right key to adjust the value, then press the enter key again
to confirm. After setting ECO function, the temp. adjustment
will be limited. If overrun is set, the temp. can be adjust out of
ECO range in allowable time.
ECO
Setting
Range of temp.
Temp.
The highest limit
ECO
of heating
The lowest limit
of cooling/dry
Return
ECO
Type
No overrun
Temp.
ECO
2
hour
Return
10:30
Thursday
01.01.2015
AM
Wired controller
Indoor unit
Wired controller
Indoor unit
Available
Unavailable
Enter
Main
10:30
Thursday
01.01.2015
AM
ON
OFF
75.0ºF
75.5ºF
Enter
Main
10:30
Thursday
01.01.2015
AM
ON
OFF
15
permitted
min
Enter
Main
Page 9
Hide quick links:
Advertisement
Table of Contents
