Components
To increase resistance, turn the adjuster
clockwise.
To decrease resistance, turn the adjuster
counterclockwise.
EWM00040
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to steer, which could result in an
accident.
EMU26261
Trim rod (tilt pin)
The position of the trim rod determines the
minimum trim angle of the outboard motor in
relation to the transom.
EMU30440
Tilt lock mechanism
The tilt lock mechanism is used to prevent the
outboard motor from lifting out of the water
when in reverse gear.
17
1. Tilt lock lever
To tilt the outboard motor up, set the tilt lock
lever to the "
" (up) position. To tilt the out-
board motor down, set the tilt lock lever to the
"
" (down) position.
EMU26332
Tilt support bar
The tilt support bar keeps the outboard motor
in the tilted up position.
ECM01660
NOTICE
Do not use the tilt support bar when traile-
ring the boat. The outboard motor could
shake loose from the tilt support and fall.
If the motor cannot be trailered in the nor-
mal running position, use an additional
support device to secure it in the tilt posi-
tion.