Setting The Programming Code - Siemens Codoor CD3500 Installation & User Manual

 CD3500 & CD4000 Installation and User manual
Codoor also incorporates a buzzer, both to confirm each key press
(if required) and to indicate "battery low" by sounding a low tone (see
section Backup Power Supply). Otherwise, the buzzer sounds to
confirm successful programming.
The programming code must be set before the unit is fitted to
the door

Setting the programming code

When Codoor is delivered, the memory is completely empty. The first
thing you have to do is to set a programming code, before you fit
Codoor to a door. To set the programming code for the first time,
connect the batteries and proceed as follows:
1. Press the reset button on the rear of Codoor and
hold it down as you press the # button for at least 2
seconds.
2. The red LED will flash quickly, accompanied by simultaneous
sounding of the buzzer
3. While buzzer sound - press ,
then enter the desired 6-digit programming code. Finish by
pressing .
4. The green LED is lit for 2 seconds. A rising tone from the buzzer
confirms that the programming code has been set.
Note! Programming must be done while the red LED flashes
and the buzzer sounds. Do not forget to write to down the
chosen digits.
Programming
Code
Code 1:
Code 2:
Code 3:
Code 4:
Code 5:
Code 6:
R R
 
Note! The first 4 digits
in the programming
code must never be
used for any of the 9
access codes.
Code 7:
Code 8:
Code 9:
+ +
# #
 