Motorola APX 5000 Service Manual page 136

Sec 1: 8-36
8.9.1.6 Assemble Main Housing Assembly (A, L
1. Stretch the Main Housing Assembly (A, L, M) side walls outward with both hands just enough
to clear the Main Chassis Assembly (E) and place it onto the radio.
2. Ensure the top edge of the housing and the bottom edge of the control top are aligned as
shown in
3. Squeeze the Main Housing Assembly (A, L, M) and the Main Chassis Assembly (E) in the
battery area until the Main Housing Assembly fully snaps in place onto the Main Chassis
Assembly.
8.9.1.7 Assemble Expansion Board Assembly (H)
Control Top Assembly Flex
1. If the Control Top Assembly (F) or VOCON Board Assembly (D) was NOT removed skip to
step 2.
Connect the Control Top Flex to the VOCON Board Assembly as shown in
2. If replacing new Control Top (21) or Main Chassis Assembly (15), add Control Top Support
Pads (23) to stainless steel backers at the locations shown on
3. If the RF Board Assembly (9) was NOT removed, skip to step 4.
Carefully align the Antenna Coax Plug to the Coax Receptacle on the RF board Assembly (C)
and slide the plug in using the Black Stick. Ensure the universal connector flex is not caught
under the antenna coax cable.
Figure 8-48.
Stretch Outwards
Figure 8-48. Place Housing into Main Chassis
Figure 8-49. Assemble Expansion Board Assembly
Disassembly/Reassembly Procedures: Radio Reassembly
M)
,
Antenna Coax Cable Connector
Figure 8-49.
Figure 8-50.