Makita BO4900V Instruction Manual page 5

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing abrasive paper
For conventional type of abrasive paper with
pre-punched holes (standard equipment):
1
2
001682
Turn the clamp lever counterclockwise. Insert the paper
end into the clamper, aligning the holes in the paper with
those in the pad. Then return the clamp lever to the
original position to secure the paper. Repeat the same
process for the other end of the tool, maintaining the
proper paper tension.
For conventional type of abrasive paper without
pre-punched holes (optional accessory):
1
2
001683
Turn the clamp lever counterclockwise. Insert the paper
end into the clamper, aligning the paper edges even and
parallel with the sides of the base. Then return the clamp
lever to the original position to secure the paper. Repeat
the same process for the other end of the tool,
maintaining the proper paper tension.
Place the punch plate (optional accessory) over the
paper so that the guide of the punch plate is flush with the
sides of the pad. Then press the punch plate to make
holes in the paper.
1. Clamp lever
2. Conventional type
of abrasive paper
with pre-punched
holes
3. Pad for
conventional type
of abrasive paper
3
1. Punch plate
2. Conventional
type of abrasive
paper without
pre-punched
holes
For hook-and-loop type of abrasive paper with
pre-punched holes (optional accessory):
001684
Remove all dirt or foreign matter from the pad. Attach the
paper to the pad, aligning the holes in the paper with
those in the pad.
CAUTION:
Never use pressure-sensitive abrasive paper.
•
For BO4901 only
NOTE:
To use the hook-and-loop type of abrasive paper,
•
first replace the pad. Remove the pad for the
conventional type of abrasive paper from the tool
with a screwdriver.
Install the pad for the hook-and-loop type of
abrasive paper (optional accessory) on the tool.
Tighten the screws firmly to secure the pad.
2
1
004436
Installing paper dust bag
For BO4900, BO4900V only
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing cardboard
of the paper dust bag into the groove of the paper dust
bag holder.
1
001685
5
1. Hook-and-loop
1
type of abrasive
paper with
2
pre-punched holes
2. Pad for
hook-and-loop type
of abrasive paper
1. Pad
2. Screws
3. Screwdriver
3
1. Groove
2. Front fixing
2
cardboard
3. Paper dust bag
3