Sony MEX-BT4100E Service Manual page 30

MEX-BT4100E/BT4100P/BT4100U/BT4150U
Ver. 1.1
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
• X : Parts extracted from the component side.
• Y : Parts extracted from the conductor side.
• : Internal component.
f
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen
(Conductor Side) from the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Component Side) the parts face are indicated.
• Indication of transistor.
C
Q These are omitted.
B E
• Abbreviation
EA : Saudi Arabia model
MX : Mexican model
Note 1: When the complete MAIN board is replaced, the destination
setting is necessary. Refer to "NOTE THE MAIN BOARD
OR SYSTEM CONTROLLER (IC501) REPLACING" on
page 4.
Note 2: When the complete BT board or complete MAIN board (in-
cluding BT board) is replaced, it is necessary to confi rm op-
eration. Refer to "BLUETOOTH FUNCTION CHECKING
METHOD USING A CELLULAR PHONE" on page 7.
MEX-BT4100E/BT4100P/BT4100U/BT4150U
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4 W or less unless otherwise
specifi ed.
• : Internal component.
f
• C : Panel designation.
Note: Note:
The components identi- Les composants identifi és
fi ed by mark 0 or dotted par une marque 0 sont
line with mark 0 are criti- critiques pour la sécurité.
cal for safety. Ne les remplacer que par
Replace only with part une pièce portant le nu-
number specifi ed. méro spécifi é.
• A : B+ Line.
• Power voltages is dc 14.4V and fed with regulated dc
power supply from ACC and BATT cords.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : TUNER (FM)
< > : CD PLAY
* : Impossible to measure
• Voltages are taken with VOM (Input impedance 10 M).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : AUDIO
f : TUNER
: CD
J
d : USB
h : SIRIUS/XM
: AUX
E
a : Bluetooth
Note 1: When the complete MAIN board is replaced, the destination
setting is necessary. Refer to "NOTE THE MAIN BOARD
OR SYSTEM CONTROLLER (IC501) REPLACING" on
page 4.
Note 2: When the complete BT board or complete MAIN board (in-
cluding BT board) is replaced, it is necessary to confi rm op-
eration. Refer to "BLUETOOTH FUNCTION CHECKING
METHOD USING A CELLULAR PHONE" on page 7.
• Circuit Boards Location
KEY board
– Front panel –
30 30
SERVO board
SENSOR board
TUX-DSP02
(Tuner unit)
MAIN board
BT board
– Main unit –