Maintenance - Makita BO5010 Instruction Manual

Switch action (Fig. 9)
CAUTION:
Before plugging in the tool, always be sure that the tool is
switched off.
To start the tool, press the '' I (ON)'' side of the switch. To
stop, press the ''O ( OFF )'' side of the switch.
Operation (Fig. 10)
Turn the tool on and wait until it attains full speed. Then
gently place the tool on the workpiece surface. Keep the
pad flush with the workpiece and apply slight pressure on
the tool.
CAUTION:
• Never switch on the tool when it is in contact with the
workpiece surface, causing an injury to operator.
• Never run the tool without the abrasive disc. You may
seriously damage the pad.
• Never force the tool. Excessive pressure may decrease
the sanding efficiency, damage the abrasive disc or
shorten tool life.
D O
• ON-LOA FF-LOAD
The sanding pad rotates clockwise during the loaded
operation, but it may rotate counterclockwise during the
no-load operation.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
5