Table of Contents
Advertisement
Spraying
The water spray can be used to help iron heavy fabrics or difficult areas (collars,
pockets, sleeves, creases, etc). It can also be used when ironing delicate fabrics which
cannot be steam ironed.
Make sure there is water in the tank. Press the spray button
water.
Anti-drip feature
When the temperature of your iron is insufficient to create steam, the supply of water is
cut off automatically to avoid any drips from the soleplate.
Anti-scale filter
Your iron is fitted with a permanent anti-scale filter. This filter is fixed and cannot be
removed for cleaning.
The filter is designed to reduce the build-up of limescale inside your iron. Limescale
occurs during steam ironing due to water hardness.
Water hardness varies from one area to another. The effectiveness of the filter will
depend on how 'hard' your water is.
Care and Cleaning
Warning: Do not use harsh abrasives, chemical cleaners or solvents to clean
the exterior of your iron.
Allow your iron to completely cool down and wipe the soleplate with a soft damp cloth. If
polyester has burnt to the soleplate, iron a damp cotton cloth while your iron is still hot.
Wipe over the rest of your iron with a soft damp cloth then wipe dry.
Self-cleaning
Only press the self-clean button when you want to activate the self cleaning
system. Never press the self-clean button when ironing.
The self-clean function removes scale and impurities. Use the self-clean function once
every two weeks. If the water in your area is very hard, the self clean function should be
used more frequently.
1.
Ensure your iron is switched off and unplugged from the mains supply socket.
2.
Set the steam control
3.
Fill your iron with water to the MAX level.
4.
Stand your iron on its heel rest, plug in and switch on at the mains supply.
5.
Set the temperature control
heat up until the temperature indicator light
6.
Unplug your iron and hold it over a sink with the soleplate facing downwards.
7.
Press and hold the self-clean button
the holes in the soleplate along with any impurities.
8.
Release the self-clean button after one minute or when the water tank is empty.
9.
Stand your iron on its heel rest, plug it in to the mains supply socket and switch on.
When the temperature indicator light comes on, iron an old piece of cloth to allow
any remaining water to escape.
10. After use, switch off and unplug your iron from the mains supply and allow it to fully
cool. Empty out any remaining water.
Cleaning the steam holes
To remove any build-up in or around the steam holes which may affect steam
performance, use a cotton wool tip moistened with methylated spirits. Wipe off the
methylated spirits with a damp cloth then dry the soleplate.
to the no steam (0) position.
w
to the highest (MAX) setting. Allow your iron to
y
. Hot water and steam will be ejected from
s
to produce a spray of
r
comes on.
t
5
Advertisement
Table of Contents
