To Convert Surface Burners; Lp Gas Orifice Spud Chart For Surface Burners - KitchenAid KSGG700E Installation Instructions Manual

3=
4.
Remove plastic cover from gas pressure regulator cap.
Turn gas pressure regulator cap counterclockwise with a 5/8"
(1.6 cm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
B
C
Side view before
Side view after
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
",I,LP" is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas to LP Gas)
1. Remove burner cap.
2. Remove the burner base.
......... C
A ................................ '......... '_........................... D
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
3=
Apply masking tape to the end of a 7
mm (9/32 H)
nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and
remove by turning it counterclockwise and lifting out. Set gas
orifice spud aside.
A D
4=
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
Remove the orifice spuds shipped in the literature package in
the oven. Gas orifice spuds are stamped with a number,
marked with 1 color dot, and have a groove in the hex area.
Replace the Natural gas orifice spud with the correct LP gas
orifice spud.
A. LP groove
Refer to the following chart for correct LP gas orifice spud
placement.
LP Gas Orifice Spud Chart for Surface Burners
Burner Rating Color Size (mm)
ID
Number
L105
L85
L65
L32
14,000 BTU Silver 1.05
8,000 BTU Red/Orange 0.85
5,000 BTU Red/Blue 0.65
1,200 BTU BlacWOrange 0.32
NOTE: Refer to the Model Number and Serial Number Plate
located on the oven frame behind the top right side of the oven
door for proper sizing of spuds for each burner location.
5. Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT: Keep the Natural gas orifice spuds in case of
reinstallation with Natural gas.
6. Replace the burner base.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
17