Matrix Outputs; Routing, Features - Yamaha M7CL-48 Quick Start Manual

Matrix outputs; routing, features.

M7CL has 8 matrix outputs. These are fed by all channels, inputs and outputs. So it is a 75 x 8 ways matrix in
M7CL-48/ES and 59 x 8 ways in M7CL-32. The matrix masters are assigned to the Centralogic™ area by pressing
the grey [MATRIX] navigation key.
Matrix master screen.
The matrix master screen gives information about the
eight matrix outputs, EQ and Dynamics activity, routing
and name information, etc.
Note; In these views the coloured knobs show sends from the Mix buses, not to them. Note;
Note; From a single input Note;
channel view, you can get
to the MATRIX sends by
pressing the tab at the
top of the MIX send panel.
Tip; Or use MTRX Sends Tip;
on Faders
M7CL Quick Start Guide Part 1
Matrix single channel view
The matrix single channel view gives detail of the
parameter settings and feedback from encoder
adjustments. It differs from the input channel view;
there is no HA or digital ATT to control, there is only one
dynamic unit, and there is no DCA assignment.
You can check the output routing of the matrixes
on the table on page 16 of this guide. Tip
SETUP>OUTPORT SETUP on the console.
To change these or route another matrix, press either
the name on the overview or the grey patch button on
the single channel view (where HA is on inputs) to go
to the PATCH/NAME pop-up. From this pop-up you can
change matrix patches.
18
Tip ;or go to