Trailing Arm, Rear Axle And Coil Spring Inspection; Rear Axle Bush Inspection - Suzuki Swift Sport 2004 Service & Repair Manual

12) Fill reservoir with brake fluid and bleed brake
system. For bleeding operation, see "Air Bleeding of
Brake System in Section 4A".
13) Install wheel and tighten wheel nuts to specified
torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
14) Adjust parking brake cable. For adjustment, refer to
"Parking Brake Inspection and Adjustment in Section
4D".
15) Lower hoist and bounce vehicle up and down
several times to stabilize suspension.
16) Tighten shock absorber lower nuts (1) and trailing
arm bolts (2) to specified torque.
NOTE
When tightening these nuts and bolts, be
sure that vehicle is not on hoist and in
unloaded condition.
Tightening torque
Rear shock absorber lower nut (a): 90 N·m (9.0
kgf-m, 65.0 lb-ft)
Trailing arm bolt (b): 73 N·m (7.3 kgf-m, 53.0 lb-
ft)
1, (a)
17) Perform brake test (foot brake and parking brake).
18) Check each installed part for fluid leakage.
Trailing Arm, Rear Axle and Coil Spring
Inspection
• Inspect for cracks, deformation or damage.
• Inspect bushing for damage, wear or breakage.
Replace any defective part.

Rear Axle Bush Inspection

Inspect for cracks, deformation or damage. Replace any
defective part.
2, (b)
I6RS0B230008-01
Rear Suspension: 2C-9
S7RS0B2306009
I4RS0A230031-01
S7RS0B2306010