Operating Other Pioneer Components With This Unit's Sensor; Switching Components On And Off Using The 12 Volt Trigger - Pioneer SC-LX73 Operating Instructions Manual

03 Connecting your equipment
Operating other Pioneer components
with this unit's sensor
Many Pioneer components have SR CONTROL jacks
which can be used to link components together so that
you can use just the remote sensor of one component.
When you use a remote control, the control signal is
passed along the chain to the appropriate component.
Important
• Note that if you use this feature, make sure that you
also have at least one set of analog audio, video or
HDMI jacks connected to another component for
grounding purposes.
1 Decide which component you want to use the
remote sensor of.
When you want to control any component in the chain,
this is the remote sensor at which you'll point the
corresponding remote control.
2 Connect the CONTROL OUT jack of that component
to the CONTROL IN jack of another Pioneer component.
Use a cable with a mono mini-plug on each end for the
connection.
Continue the chain in the same way for as many
components as you have.
Note
1 • If you want to control all your components using this receiver's remote control, see Setting the remote to control other components on page 79
(SC-LX83)/page 92 (SC-LX73).
• If you have connected a remote control to the CONTROL IN jack (using a mini-plug cable), you won't be able to control this unit using the
remote sensor.
40
En
MONITOR OUT
ZONE 2 OUT
Y
P P
B R
ANTENNA
SPEAKERS
AM LOOP FM UNBAL 75
CONTROL IR 12 V
RS-232C
IN 1
TRIGGER
IN 1
(OUTPUT
(OUTPUT 5 V
IN 2 12 V
150 mA MAX)
OUT
TOTAL
2
150 mA MAX)
OUT
CU-RF100
IN OUT
IN
CONTROL CONTROL
Switching components on and off using
the 12 volt trigger
You can connect components in your system (such as a
screen or projector) to this receiver so that they switch on
or off using 12 volt triggers when you select an input
function. However, you must specify which input
1
functions switch on the trigger using the The Input Setup
menu on page 45. Note that this will only work with
components that have a standby mode.
HDMI
ASSIGNABLE
COMPONENT VIDEO
RS-232C
(OUTPUT 5 V
150 mA MAX)
CU-RF100
• Connect the 12 V TRIGGER jack of this receiver to
the 12 V trigger of another component.
Use a cable with a mono mini-plug on each end for the
connection.
After you've specified the input functions that will switch
on the trigger, you'll be able to switch the component on
or off just by pressing the input function(s) you've set on
page 45.
OUT
It is also possible to have the component switch not when
the input function is switched, but when HDMI OUT is
switched. For details, see HDMI Setup on page 68.
BD IN IN IN IN
IN 1 2 3 4
1 4
ASSIGNABLE
(DVD)
IN 1
(DVR/BDR)
IN 2
ZONE2 ZONE3 DVD TV/SAT VIDEO DVR/BDR
OUT OUT IN IN IN OUT IN
(VIDEO)
IN 3
MONITOR OUT
ZONE 2 OUT
Y P P
B R
ANTENNA
SPEAKERS
SELECTABLE
SEE INSTRUCTION
AM LOOP FM UNBAL 75
MANUAL
CONTROL IR 12 V
CAUTION:
IN 1
TRIGGER
SPEAKER IMPEDANCE
IN 1
6 Ω - 16 Ω .
(OUTPUT
IN 2
12 V
OUT
TOTAL
2
150 mA MAX)
OUT
12 V TRIGGER
INPUT
OUT 1 OUT
(CONTROL)
MONITOR
OUT
VIDE
PHONO CD
IN IN
SIGNAL
GND
FRONT HEIGHT/W
R