Honeywell RCWL200A Installation Instructions Manual page 3

Safety
Before proceeding with the installation, please note the following safety warnings:
• Always follow the manufacturer's advice when using power tools and wear
suitable protective equipment (e.g. safety goggles) when drilling holes, etc.
• Before drilling holes in walls, check for hidden electricity cables and water pipes.
The use of a cable/pipe locator is advisable if in doubt.
Batteries (battery pack or batteries installed) shall not be exposed to excessive heat
such as sunshine, fire or the like; danger of damage if battery is incorrectly replaced.
Replace only with the same or equivalent type.
1. Checking Pack Contents
• Chime
• Bell push
• CR2032 battery for bell push
• 2 x screws for push
• 2 x wall plugs
• Adhesive pad
You will need:
• 3 X LR14 C size 1.5V Alkaline
batteries
• A #1 Philips-head screw driver
• A small flat bladed screwdriver
• A 1/4-in. (6 mm) drill bit
1
RCWL200A and RCWL210A
69-2112EFS—07