Assembly; Operation; Switching On And Off; Power Command Max Power/Max Runtime - Black & Decker LSW36 Instruction Manual

ThhiSproduct ca.n accept any of the batteries and
argers Hs_ea _n the cnar_ [_e_ow.
LI=ION Battery Packs and Chargers
[DescriDtien Cat. #
Batteries: LI-ION LBX36
LBXR36
LBXR2036
i Chargers: LI-ION LCS36
LCS436
NOTE: Ensure the sweeper is switched off and the battery is
removed before attaching or removing the sweeper tubes. The
tube assembly must be assembled to the housing before use.
• TUBE ASSEMBLY: To attach the inner tube to the sweeper, line
up the tube with the sweeper housing as shown in figure D. Push
the tube into the sweeper housing until the lock button engages
the lock hole in the tube. Repeat this process for the outer tube.
Z_WARNING: CUT HAZARD. When turning the toot off for tube
installation or any other reason, wait 10 seconds for the fan to stop
rotating before disassembly.
• Always switch off and remove the battery when:
• The power supply cord has become damaged or entangled.
• You leave sweeper unattended.
• Checking, adjusting, cleaning or working on sweeper.
Use sweeper only in daylight or good artificial light.
SWITCHING ON AND OFF (FIGURE E}
ZhWARNING:
USE BOTH HANDS TO
GRIP THE PRODUCT FIRMLY WHEN
SWITCHING ON.
To switch the sweeper on, slide the on/off
switch forward.
To switch the sweeper off, slide the on/off
switch back.
ZLCAUTION:
DO NOT POINT UNIT
DISCHARGE AT SELF OR BYSTANDERS.
ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF
THE OPERATION IS DUSTY. USE OF RUBBER GLOVES AND
SUBSTANTIAL FOOTWEAR IS RECOM MEN DED WHEN WORKI NG
OUTDOORS. FOR HOUSEHOLD USE ONLY.
POWER COMMAND (FIGURE F)
MAX POWER / MAX RUNTIME
The max power / max runtime feature
(F1) is located on the tool handle.
It allows you to optimize the tools
performance and boost the power as
needed.
• To choose max power, rotate dial to
setting 6.
• To maximize runtime rotate dial to
setting 1.
• For a combination of both, rotate dial to setting from 2 to 5.