NEC MP-01 User Manual page 12

OSD
Main Menu
DATE/TIME
NETWORK
PREVIEW
TIMER
LANGUAGE
VIDEO OUT
VIDEO IN
MEMORY CARD
IR CONTROL
SLIDE SHOW
Sub Menu
Date
Time
NTP Server
Time Zone
Static IP/DHCP
IP
Netmask
Gateway
DNS
MAC
Proxy
Update Mode from LAN
Power-ON/Power-OFF
Video-ON/Video-OFF
Normal
S-Video Through Out
Free
Available
Delete All Content Files
Normal
IR Lock
Normal Mode
Slide Show Mode
Video Repeat Mode
Description
Set the current Date and Time.
This is not used in this equipment.
This is not used in this equipment.
Select the IP Address setting method.
Set the IP Address used when selecting a Static IP. The default
setting is (192.168.0.2)
Set the Netmask used when selecting the Static IP. The default
setting is (255.255.255.0)
This is not used in this equipment. Leave the default setting at (192.168.0.1)
This is not used in this equipment. Leave the default setting at (0.0.0.0)
This is the MAC address for this equipment.
This is not used in this equipment. Leave the default setting at (0.0.0.0)
Set it to "Push Mode" (default setting). The "Pull Mode" is not used
with this equipment.
Preview the selected program. Select the program to preview on the "Program List".
During preview, push any button on the remote control to display the review end
menu. The preview will be displayed repeatedly until it is ended up manually.
* If the OSD menu is selected while displaying the "Slide Show Mode", the "PREVIEW" is not displayed.
Switches the equipment ON/OFF. If there is program data that set the
time for power on/off, the setting of the program data is valid, and
the timer setting is void. The time set in the program is displayed.
This is a setting for future extensions. Do not select this when using the equipment.
Select the language for the OSD menu.
Select the "VIDEO OUT" according to the Display to be used. Check the
"Read Timing from Display" item and the recommended timing for the
Display will be shown. Depending on the Display, the recommended timing
may not be set normally. In such cases, clear the check from this item.
Normally this is used.
Image from S-VIDEO input will be displayed full screen. Information
other than S-VIDEO (such as Message) will not be displayed.
This is the remaining area available for use.
This is the maximum capacity of content that can be used. As a rough
guide, it should be about 90% of the memory card capacity. (In the case of
the enclosed memory card (2 Gbytes), it is displayed at around 1.8 Gbytes.)
All content will be deleted.
Remote control operation will be locked. To release the lock, press the "MENU,"
"1," "2," and "3" buttons on the remote control in order, then wait 3 seconds. If
"OSD Menu Unlock" is displayed, the lock has been released.
The program is displayed according to the schedule set in the
Authoring Software.
This sets the mode in which the images (*.jpg, *.jpeg, *.png, *.bmp) on the
connected USB memory are displayed continuously in the order of the file names.
This sets the mode in which the moving file (*.wmv, *.mpg) on the connected
USB memory are displayed continuously in the order of the file names.
12