Status Indicator Display; Link/Act Setting; Status Setting; Vlan Setting - Yamaha SWP1-8 Owner's Manual

Status Indicator Display

The status indicators show different things depending on
the LED mode setting.

LINK/ACT setting

The status indicators show each port's link status and
connection status.
Indicator Illumination
Lit green
Flashing
Upper
green
Unlit
Lit green
Lower Lit orange
Unlit

STATUS setting

The status indicators show the loop-related port's status.
Indicator Illumination
Lit orange
Upper
Flashing
and lower
orange
Unlit

VLAN setting

The status indicators show the VLAN ID and trunk.
If DIP switch 1 is upward ([DANTE]), VLAN 1 is shown by
the upper indicator and the lower indicator unlit. VLAN 2
is shown by the upper indicator lit green and the lower
indicator unlit. Trunk is shown by upper and lower
indicators lit orange.
–: Unlit
G: Lit green
O: Lit orange
Indicators 1
Upper –
Lower –
Note
• If a number of VLANs that cannot be completely displayed
above is specified, the upper and lower indicators are lit
green.
• If multiple VLAN IDs are specified for the same port, the
upper and lower indicators are lit orange.
14
SWP1 Owner's Manual
Status
Link is established. (LINK)
Data is being transferred.
(ACT)
Link is lost.
Connected with 1000BASE-T.
Connected with 100BASE-TX.
Connected with 10BASE-T.
Status
Loop was detected, but
communication is not halted.
Loop was detected, and
communication is halted.
Loop not detected.
VLAN ID low  high
G O – – G O
– – G O O G

OFF setting

All status indicators are unlit.

Initializing the SWP1

Here's how to initialize the SWP1's internal memory,
restoring it to the factory settings.
1.
Power-off the SWP1.
2.
While pressing and holding down the [LED
MODE] button, then power-on the SWP1.
3.
The [STATUS] indicator and the [OFF]
indicator lit and all status indicators lit
orange, release the [LED MODE] button.
Initialization completed, The SWP1 will automatically
restart.
CAUTION
Do not turn off the power to the SWP1 during initialization.
Otherwise, a malfunction may occur.
NOTE
If initialization failed, contact Yamaha service personnel.
Trunk
O
O