Overview Of Jumpers - Fujitsu CREMSON MODULAR STARTERKIT User Manual

The evaluation board provides various IO-signals, which can be connected to external
devices. The controller resource functions are available on the connectors JH1
(Peripheral_1) and JH2 (Peripheral_2).
The graphic subboards can be connected via the address/data bus connectors on the richt
side JDH1 and JDH2. For more information please refer to the following pin assignments
and the schematics in the appendix.

6.1 Overview of Jumpers

Jumper Description
JP7 UART1_RxD
JP8 UART1_TxD
JP9 UART1_Clock
JP10 Flash_enable
JP11 FR_3V3
JP12 FR_5V0
JP13 Vcc3/C
JP14 HVdd
JP15 Avcc
JP16 HSTX
JP17 SELCLK
JP18 4MHz
JP19 32kHz
JP20 VCI
JP21 UART0_TxD
JP22 UART0_RxD
JP23 CAN0_TX
JP24 CAN0_RX
JP25 LEDs
Table 1: Configuration jumpers on CPU-board
Cremson Starterkit User Manual
Chapter 6 CPU Board Hardware
Standard Setting
Choose RxD of synchron
or asynchron UART1
Choose TxD of synchron
or asynchron UART1
Clock-Select for UART1 in
syncronous mode
Enable Flash on CS2 or
CS3
3,3 Volts CPU-net
5,0 Volts CPU-net
Bypass-Condensator
on/off
5,0 Volts of high current
outputs
5,0 Volts of analog net
(ADC and DAC)
Hardware-Standby
Clock-Source (4Mhz /
32kHz)
4MHz-Oszillator
32kHz-Oszillator
Filter for 32kHz-Oscillator
MAX232 TxD to UART0
MAX232 RxD to UART0
PCA82C250 TxD to CAN0
PCA82C250 RxD to CAN0
Enable LEDs
- 24 -
Jumper Position
2-3
2-3
2-3
1-2
Closed
Closed
Closed
Closed
Closed
1-2
2-3
1-2
2-3
2-3
Closed
Closed
Open
Open
Closed
© Fujitsu Microelectronics Europe GmbH