Table of Contents
Advertisement
INSTALLATION PARTS
1. Bracket (A)
8. Lock washer
M 6
x4
13. Power Cable
Yellow
WIRING
4.
Reset button
Be sure to press this button when all wiring is completed or when Car battery is replaced.
When a
malfunction occurs during
1) The magazine will be automatically ejected
2) Empty the magazine, and insert it again.
The disk on the turntable is automatically housed, and the magazine will be ejected after about 8 seconds.
l
3) Press the commander reset button after the magazine has been ejected.
Normal operation will then return.
2. Bracket (9)
3. HexaQonal bolt
with washer
9. Fiat washer
M 5
x4
x4
CD play, press the
in about 3 seconds after RESET button
5. Changer selector switch
Do not use this switch if only 1
It
On how to use it, refer to the operation manual of the divider unit
5. Hexagonal bolt 6. Tapping SCREW
4. Hexagonal bolt
with washer
11. Double sided tape
10. seal
x l
x2
1. DIN cable (&pin)
Connect this cable to the FXR-61TB, LB, GB/FXR-71TB, LB/FM
Modulator/Ground Isolator or Divider unit.
Power wire (YELLOW)
ect this wire to a terminal which is always energized.
n fuse replacement is necessary, use only a 5 amp fuse.
3. Ground wire (BLACK)
Attach this wire to the chassis of the car. Be sure that the surface
is free of
and is not rusty. If a proper ground connection is
paint,
not made, the CD changer may not operate correctly and stray
noise
may be picked up by the unit.
button and follow this procedure.
CD
is used only when 2
with washer
12. DIN 8pin cable
is pressed.
CD
changer is being used.
changers (FXD-C200) are attached.
Advertisement
Table of Contents
