Removing Expansion Cards; Figure 2-9. Correctly Installed Expansion Card - Dell Dimension L Series Reference And Troubleshooting Manual

support.dell.com
front of
card-edge
connector
expansion-card
connector

Figure 2-9. Correctly Installed Expansion Card

8. Connect any cables required for the card as described in the documentation that
came with the card.
9. Rotate the power supply back into place, re
reconnect your computer and devices to their electrical outlets and turn them on.
10. Refer to the documentation that came with the expansion card for information on
installing any required drivers for your operating system.

Removing Expansion Cards

To remove an expansion card, perform the following steps:
1. Remove the computer cover according to the instructions in "Removing and
Replacing the Computer Cover" found earlier in this chapter.
2. Rotate the power supply according to the instructions in "Rotating the Power
Supply Away From the System Board" found earlier in this chapter.
3. If necessary, disconnect any cables connected to the card.
4. Remove the screw from the card-mounting bracket.
5. Grasp the card by its top corners, and ease it out of its connector.
k into place, replace the computer cover, and
Installing Upgrades on the System Board
expansion card
card-mounting
bracket
2-13