Selecting Beeper Volume using Trigger
The scanner emits a short beep when it successfully reads a bar code. To change the volume of the beep either
scan the appropriate bar code in
Press and hold the trigger for an extended period of time (approximately 5 seconds). The scanner cycles
1.
through the available settings emitting a 2-beep tone at each setting.
To select a particular setting, release the trigger after you hear the desired 2-beep tone.
2.
LED Definitions
In addition to beeper sequences, the scanner communicates with the user using an LED display.
LED flashes that display during scanning.
Standard LED Definitions
Table 2-2
LED
Off
Green
Momentary flash
Slow continuous flashing
Fast continuous flashing
Beeper Volume on page
4-5, or use the trigger as follows:
No power is applied to the scanner.
The scanner is on and ready to scan.
A bar code was successfully decoded.
The scanner is in programming mode.
There is a internal problem; the laser is shut off for regulatory reasons.
Indication
Scanning
2 - 7
Table 2-2
defines