Step 2: Connecting The Video Cords - Sony DVP-NS508P Operating Instructions Manual

Step 2: Connecting the Video Cords

Connect this player to your TV monitor, projector, or audio component such as an AV amplifier
(receiver) using a video cord. Select one of the patterns A or B, according to the input jack on
your TV monitor, projector, or audio component.
In order to view progressive signal (525p or 625p) pictures with a compatible TV, projector, or
monitor, you must use pattern B.
A
TV, projector, or
audio component
l : Signal flow
Video input jack
A
You will enjoy standard quality images.
Component video input jacks
B
(Y, P /C , P
B B
You will enjoy accurate colour reproduction
and high quality images.
If your TV accepts progressive 525p/625p
format signals, use this connection and set
"PROGRESSIVE (COMPONENT OUT
ONLY)" to "ON" in "SCREEN SETUP"
(page 51) to output progressive signals.
When connecting to a standard 4:3 screen TV
Depending on the disc, the image may not fit
your TV screen. To change the aspect ratio,
see page 50.
To change the colour system
If the on-screen menu of the player does not
appear on the connected TV, switch the
14
(yellow)
INPUT
VIDEO
L
AUDIO
R
to LINE OUT (VIDEO)
(green) (blue)
Component video
cord (not supplied)
/C )
R R
Audio/video cord (supplied)
(yellow)
to COMPONENT
VIDEO OUT
(red)
player's colour system to match the colour
system of the TV (NTSC or PAL).
First turn off the player by pressing "/1, and
then press "/1 again while holding down x
on the player. The player turns back on, and
the name of the colour system scrolls across
the front panel display.
Note
Do not connect a VCR, etc., between your TV and
the player. If you pass the player signals via the
VCR, you may not receive a clear image on the TV
screen. If your TV has only one audio/video input
jack, connect the player to this jack.
CD/DVD player
CD/DVD player
COMPONENT
B
VIDEO IN
Y
(green)
P /C
B B
(blue)
P /C
R R
(red)
TV, projector, or
audio component
VCR
Connect
directly
TV